whedf.blogg.se

Now that everything is wired up, you should spend a couple of minutes cleaning up the cables. *Note: The z-stop cable will no longer be used.

Z-Stop Port Wire Color Board Pin Board Label Black GND G White PC14 OUT If you decide to go this route, the wires should be connected in the order shown below.īLTouch Port Wire Color Board Pin Board Label Blue GND G Red +5V V Yellow PA1 IN Wire Color Board Pin Board Label Blue GND G Red +5V V Yellow PA1 IN Black GND G White PC14 OUTĪnother common way to connect the BLTouch is to connect the probe stop into the z-stop port and not use the z-stop at all. Here is an overview of what each wire is for.

If you go this route, they should be connected in this order shown in the picture below. This option provides an extra layer of protection in case the probe on the BLTouch has issues. The standard way to connect the BLTouch would be to connect all five wires to the BLTouch port.